BGConsortium.com - Newest Of All Information Centers

The primary factor that determines uptime for servers in a colocation facility is power. Power outages will knock a network offline and even damage hardware such as motherboards, memory, and hard drives. Despite how intrinsic power is to keeping businesses connected to their networks, only 2% to 3% of colocation facilities have the right power systems in place. The other 97% of facilities most commonly lack redundancy, multiple units carry the energy load even if one unit fails, or have units that are running above capacity, so a unit failure will cause the other units to overload and fail. Every part of the power system uninterruptible power supplies (UPS), transfer switches or circuit breakers, generators, and power distribution units (PDU) should be redundant and running below capacity.

Problem 1: Non-redundant Power Grids
Multiple PDUs connected to separate power grids and multiple UPSs should be designed into the colocation facility to offset a power grid failure. Colocation facilities with redundant power grids can connect customer servers to different grids at the same time, so that even if one goes offline, the other will work, keeping the network running without interruption.

Problem 2: Non-redundant UPSs
The UPSs supply power during an outage until the generator can come online; if the UPSs do not turn on immediately at the time of failure, then the network will go down. Even with high quality UPSs, failures are common, so it is critical for there to be multiple redundant UPS units in an n+1 configuration all of the necessary UPSs, plus an extra. Functionally, this means that each UPS runs sufficiently below capacity to handle a unit failure without the other units overloading. If there are two UPSs, then each unit must run below 50%, so that if one fails, the other can continue without overloading. If there are three units, each must run below 66%; four units, below 75%. The current load is shown on the display on the front of the UPS.
Read more…

Get your confidential data secured with the help of fully automated back up. Such automated back ups can eliminate the need for traditional tape based back up solutions. Data is stored in remote mirrored locations for resilience. If the back-up is too large to transfer over the available bandwidth, a snapshot is created and saved to a physical device, which is then uploaded to the back-up platform.

Data back up and Recovery!

The backup process starts after the installation and registration of backup software on the user’s system. The backup process automatically detects important data files that are located anywhere on your hard disk and creates a backup set. You can fine-tune your backup set by adding and deselecting files and folders.

Back ups are quick and efficient, even over a dial up connection!
After the file selection is made you can initiate the backup process at any time. The initial backup will be the most time consuming since you must transfer all of your files to the data center. Online backup process has features such as Send-Once technology and file compression to perform this transfer as efficiently as possible. Easy backup utility unlike the conventional back up makes your backup process quick and very easy to perform. The Backup Solution software can store multiple versions of each file backed up during the last three months. This backup restore utility allows you to quickly restore a prior version of a file if an accident occurs overwriting a file template without changing the name.
Read more…