BGConsortium.com - Newest Of All Information Centers

BGP is one of the most complex topics you’ll study when pursuing your CCNP, if not the most complex. I know from personal experience that when I was earning my CCNP, BGP is the topic that gave me the most trouble at first. One thing I keep reminding today’s CCNP candidates about, though, is that no Cisco technology is impossible to understand if you just break it down and understand the basics before you start trying to understand the more complex configurations.

BGP attributes are one such topic. You’ve got well-known mandatory, well-known discretionary, transitive, and non-transitive. Then you’ve got each individual BGP attribute to remember, and the order in which BGP considers attributes, and what attributes even are… and a lot more! As with any other Cisco topic, we have to walk before we can run. Let’s take a look at what attributes are and what they do in BGP.

BGP attributes are much like what metrics are to OSPF, RIP, IGRP, and EIGRP. You won’t see them listed in a routing table, but attributes are what BGP considers when choosing the best path to a destination when multiple valid (loop-free) paths exist.

When BGP has to decide between such paths, there is an order in which BGP considers the path attributes. For success on the CCNP exams, you need to know this order. BGP looks at path attributes in this order:

Highest weight (Cisco-proprietary BGP value)

Highest local preference (LOCAL_PREF)

Prefer locally originated route.

Shortest AS_PATH is preferred.
Read more…

Planning for success on the CCNA, CCNP, and other Cisco exams is much like taking a trip in your car. You’ve got to plan ahead, accept the occasional detour, and just keep on going until you get there. But what do you do before you get started?

Create a road map - for success.
Read more…

Passing the BSCI exam and earning your CCNP is all about knowing the details, and when it comes to EIGRP SIA routes, there are plenty of details to know. A quick check in a search engine for “troubleshoot SIA” will bring up quite a few matches. Troubleshooting SIA routes is very challengin in that there’s no one reason they occur.

View the EIGRP topology table with the show ip eigrp topology command, and you’ll see a code next to every successor and feasible successor. A popular misconception is that we want these routes to have an “A” next to them - so they’re active. That’s what we want, right? Active routes sound good, right?
Read more…

To earn your CCNP certification and pass the BCMSN exam, you’ve got to know what HSRP does and the many configurable options. While the operation of HSRP is quite simple (and covered in a previous tutorial), you also need to know how HSRP arrives at the MAC address for the virtual router - as well as how to configure a new MAC for this virtual router. This puts us in the unusual position of creating a physical address for a router that doesn’t exist!

The output of show standby for a two-router HSRP configuration is shown below.

R2#show standby

Ethernet0 - Group 5

Local state is Standby, priority 100

Hellotime 3 sec, holdtime 10 sec

Next hello sent in 0.776

Virtual IP address is 172.12.23.10 configured

Active router is 172.12.23.3, priority 100 expires in 9.568

Standby router is local

1 state changes, last state change 00:00:22

R3#show standby

Ethernet0 - Group 5

Local state is Active, priority 100

Hellotime 3 sec, holdtime 10 sec

Next hello sent in 2.592

Virtual IP address is 172.12.23.10 configured

Active router is local

Standby router is 172.12.23.2 expires in 8.020

Virtual mac address is 0000.0c07.ac05

2 state changes, last state change 00:02:08
Read more…